Elastron G (SEBS based)

Elastron G are thermoplastic elastomer (TPE) compounds based on SEBS (Styrene Ethylene Butylene Styrene) which shows some of rubber properties at ambient temperature.  And they can be processed with various methods such as injection, extrusion or blow moulding. Additionally, Elastron G has been especially created for marketing demands and meeting customer requirements.

Elastron G Series:

G 100 Series
General Purpose - Injection
G 101 Series 
General Purpose - Injection & Extrusion
G 103 Series 
High Flow
G 200 Series 
High Temperature Resistant & Excellent Compression Set - Injection
G 201 Series 
High Temperature Resistant & Excellent Compression Set - Injection & Extrusion
G 250 Series 
Automotive Weatherseal
G 103 - G 303 Series
Floor Mat
G 300 Series
Semi Filled - Injection
G 301 Series
Semi Filled - Injection & Extrusion
G 400..N Series
Unfilled - Injection
G 401..N Series
Unfilled - Injection & Extrusion
G 400..T Series
Unfilled Transparent - Injection
G 401..T Series
Unfilled Transparent - Injection & Extrusion
G 418 Series
G 500..PA Series
PA Bondable
G 500..ABS Series
ABS & PC Bondable
F.G 500..ABS Series
Food Contact - ABS & PC Bondable
G 510..ABS Series
High Performance & Excellent UV Resistance - ABS & PC Bondable
G 500..PS Series
PS Bondable - Injection
G 501..PS Series
PS Bondable - Injection & Extrusion
G 601 Series
Halogen Free Flame Retardant (HFFR)
P.G 400 Series
Medical - Injection
P.G 401 Series
Medical - Injection & Extrusion
F.G 100 Series
Food Contact - Injection
F.G 300 Series
Food Contact & Semi Filled - Injection
F.G 400 Series
Food Contact & Unfilled - Injection
F.G 401 Series
Food Contact & Unfilled - Injection & Extrusion

Advantages of Elastron G:

  • Service temperature -40˚C to +130˚C
  • Wide hardness range (0 ShA- 60 ShD)
  • Resistance to weathering, ozone, UV and impact
  • Recyclable
  • Provides quite higher saving on the processing cost
  • Non hygroscopic, pre drying is not necessary except G20X and G500 series
  • Adhesion to PA, ABS, PS and PC engineering plastics
  • Resistance to acid, base and detergents
  • Abrasion resistance
  • Some special grades, resistant to bacterial attack and fungus growth
  • Antistatic compounds available
  • Many grades conforming to FDA regulations
  • Available in translucent and transparent forms
  • Density changes between 0,89 and 1,25 g/cm³